Differences

This shows you the differences between two versions of the page.

--- ethadapter2g [2014/05/21 13:27]
twdorris
+++ ethadapter2g [2024/03/15 11:16] (current)
@@ Line 1: / Line 1: @@
 ====== Ethanol Sensor to 2G/EVO1-3 SD Cable Adapter ======
+===== MAF connector wires =====
@@ Line 5: / Line 8: @@
-|  {{:ethanolsensor:eth2g-pin-insert.png?direct&161x200}}  |  {{:ethanolsensor:eth2g-pin-done.png?nolink&118x200}}  |
+|  {{:ethanolsensor:eth2g-pin-insert.png?direct&161x200}}  |  {{:ethanolsensor:eth2g-pin-done.png?direct&118x200}}  |
 |  **(click to enlarge)**   |  **(click to enlarge)**   |
@@ Line 12: / Line 15: @@
-  * Red/White
+  * White/Red
-  * Pink/Gray
+  * Gray/Pink (or Gray/Violet)
-  * Yellow/Black
+  * Black/Yellow
+Note that cables manufactured after 8/8/2016 use a violet wire in place of the previously used pink wire. So one additional possible combination is:
+  * Gray/Violet
@@ Line 23: / Line 32: @@
-If you have a yellow/back adapter, just use the yellow wire in place of red and use the black in place of white.
+If you have a yellow/black adapter, just use the yellow wire in place of red and use the black in place of white.
+\\
+===== Ground wire =====
+The black wire with ring terminal coming off the ethanol connector needs to go to a good, **clean**  chassis ground point.
 \\

ECMTuning - wiki